I use a small subapp to control the jump to other frames then. Means first i open the framejump subapp and then jump to this and that frame in the subapp then. Works fine. With one little problem.

I have set all my background colours to a dark colour. So normally you shouldn't notice a colour difference in the short moment when it loads the framejump frame and then jumps to the frame i need it to.

But the background colour in the short moment where it jumps to the next frame is not equal the other frames, and not equal the colour i have setup. It is a light grey. A system colour grey. No matter how i setup the frame.

Here some screenshots about the problem:

This is my initial frame where i jump to another frame then:



In the moment it jumps the frame becomes grey. That`s the part i dislike. It's like a flash effect:



Then it goes on with another funny thing. Because it is setting the width of the next frame in one cycle ...



... and the height in another cycle.



But resizing the window stands in one event.