User Tag List

Results 1 to 2 of 2

Thread: Rounding Values up or down

  1. #1
    No Products Registered

    Join Date
    Jun 2006
    Posts
    301
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Rounding Values up or down

    In the expression editor I realise you can round a value to the nearest full number by putting 'round' in the expression, but how can I force it to round up or down?
    I looked through the manual but nothing like this was listed in the expression editor section...

  2. #2
    No Products Registered

    Join Date
    Oct 2006
    Location
    Sweden
    Posts
    1,141
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Re: Rounding Values up or down

    I think it is Ceil() and Floor(). Int() kind of acts like Floor() too.

Similar Threads

  1. Rounding Down Counters
    By etrose in forum Multimedia Fusion 2 - Technical Support
    Replies: 3
    Last Post: 13th November 2011, 09:41 PM
  2. Rounding Down
    By etrose in forum Multimedia Fusion 2 - Technical Support
    Replies: 3
    Last Post: 7th November 2011, 11:32 AM
  3. Counters Rounding Down
    By Arnax in forum Multimedia Fusion 2 - Technical Support
    Replies: 2
    Last Post: 1st January 2008, 10:41 AM
  4. Rounding up/down
    By MechatheSlag in forum Multimedia Fusion 2 - Technical Support
    Replies: 4
    Last Post: 17th June 2007, 11:43 AM
  5. Rounding decimals?
    By Crossbones in forum Multimedia Fusion 2 - Technical Support
    Replies: 1
    Last Post: 11th October 2006, 09:01 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •