Suggestion: "Find and Replace" feature for events

[Sebaceous]

I had to add the same condition to 86 events then realised I'd added the wrong condition (when obj is visible instead of invisible), and had to do all 86 again. Most of the events already had a lot of conditions so even in my monitor's highest resolution, a lot of scrolling had to be done.

Perhaps the monotomy could have been reduced if my event writing was a bit smarter but nonetheless:

If there was a Find and Replace feature this could have been done in seconds.

[Stephen]

I think this is on the wishlist for MMF3.

stephen1980

[Surmulot]

Yes, that is very much needed. I suppose it is difficult to implement because MMF lacks this feature since the beginning.