Scrolling Vertical

[Rabagast]

Hi!

I Have a ball that always is jumping vertically when it hit a platform. My problem is: I just want it to scroll upwards when it's jumping. When it's falling, I don't want it to scroll downwards. Just scrolling upwards.

I tried to set a flag off when it's jumping and on when it's falling, but there was a little bit problem with the screen when it's jumping again.

What is the best way to do this?
Thanks.

[LB]

Compare Alterable value of Ball to < Y position of ball: Set Alterable Value to Y position of ball, set virtical scrolling in frame to Y position of ball

[Rabagast]

Hmmm, it doesn't seem to work.
The screen is not scrolling. Have you tested it by your self?

[LB]

Yes I have and it works fine.

[Rabagast]

Ok, but what do I wrong? This is what I have done:

+Alterable Value A of "Ball"<Y( "Ball" )
--Set Alterable Value A to Y( "Ball" )
--Center Display at Y=Y( "Ball" )

Shall I put all of this in one event?

[LB]

It was meant to all be one event, ther than that that is the correct way.

[Rabagast]

But something must be wrong, since it's not working

[RickyRombo]

I hope this helps:
http://www.box.net/shared/eidq53g9o7

[Rabagast]

I hope this helps:
http://www.box.net/shared/eidq53g9o7

I looked at your example, but I'm using Platform Movement Object.
I tried to edit your example and use PMO, but it doesn't seem to work properly.

Is it some other way to do this using "Platform Movement Object"?

[LB]

If you did what I told you then yes... I will make an example for you. I will post it later.